| Last Modified: 11-29-2007 | 1.6 G | |
| Service Category: Vehicle Exterior | Section: Sliding Roof/Convertible | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000033MT003X |
| Title: SLIDING ROOF / CONVERTIBLE: SLIDING ROOF SWITCH ASSEMBLY: INSPECTION (2008 Sequoia) | ||
INSPECTION
1. INSPECT SLIDING ROOF SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Switch Condition |
Specified Condition |
|---|---|---|
|
1 (UP) - 5 (E) |
TILT switch is pressed to up |
Below 1 Ω |
|
1 (UP) - 5 (E) |
TILT switch is not pressed to up |
10 kΩ or higher |
|
2 (DOWN) - 5 (E) |
TILT switch is pressed to down |
Below 1 Ω |
|
2 (DOWN) - 5 (E) |
TILT switch is not pressed to down |
10 kΩ or higher |
|
4 (OPN) - 5 (E) |
SLIDE switch is pressed to open |
Below 1 Ω |
|
4 (OPN) - 5 (E) |
SLIDE switch is not pressed to open |
10 kΩ or higher |
|
3 (CLOSE) - 5 (E) |
SLIDE switch is pressed to close |
Below 1 Ω |
|
3 (CLOSE) - 5 (E) |
SLIDE switch is not pressed to close |
10 kΩ or higher |
If the result is not as specified, replace the switch.
|
|